Filter
Top Products
VLAN Management
Page 4-39
To view the summary for other modules, type a command as shown at the
bottom of the screen.
Displaying a VLAN FID-VID Association Summary
To view a summary of the FIDs and their associated VIDs, type v in the
Configuration Menu to access the VLAN Management Menu, then type f
to access the VLAN FID-VID Association summary. A screen similar to
Figure 4-13 appears.
Figure 4-13 VLAN FID-VID association summary
Resetting VLAN Configuration to Defaults
To reset the security measures on the IntraCore 8000 to the factory defaults,
access the VLAN Management Menu by typing v in the Configuration
Menu. Then type r to reset all of the VLAN configurations that have been
changed back to the factory-set defaults.
Configuring GVRP
GARP VLAN Registration Protocol (GVRP) allows an above-end station to
to be registered as wanting to join a specific VLAN. This creates a dynamic
VLAN topology that responds to VLAN traffic; until it sees activity from the
specific VLAN, the registered station doesn’t appear to be part of that
VLAN.
Figure 4-14 A three-switch network with VLANs 1, 2, and 3
IntraCore 8000 FID Summary
+-----+-------------------------------------------------------------+
FID | VIDs |
+-----+-------------------------------------------------------------+
00 | 001
+-----+-------------------------------------------------------------+
01 | 1024
+-----+-------------------------------------------------------------+
VIDs 1, 2, 3 VIDs 1, 3 VIDs 2, 3
ABC