Filter
Top Products
Image File Downloading Configuration
Page 3-43
Current Settings
Table 3-11 describes the settings shown in the X/Y/Z Modem Image File
Downloading Menu.
Table 3-11 X/Y/Z Modem Image File Downloading settings
Performing a Software Upgrade
Use the following procedure to upgrade the IntraCore 8000 software through
its serial (console) port.
1 In the Image File Download Configuration Menu, type x
to open the X/Y/Z Modem Image File Downloading
Menu.
2 Type x, y, or z to select the corresponding modem proto-
col.
K Note: For information about these protocols, see the
manual for your communications software.
3 Type c to select the console baud rate. The Baud Rate Set-
ting Menu appears, as shown in Figure 3-24. The maxi-
mum baud rate currently supported is 57,600 bps.
Setting Description
Bank 1 Image Version/
Date
The version number and compilation date of runtime code that
is stored in memory Bank 1 on the IntraCore 8000.
Bank 2 Image Version/
Date
The version number and compilation date of runtime code that
is stored in memory Bank 2 on the IntraCore 8000.The (Run-
ning) designation indicates that the runtime code is currently
running on this Bank.
Download Protocol Current setting of the IntraCore 8000’s serial download proto-
col.
Current Baud Rate Transmission rate for the IntraCore 8000’s serial port.
Destination Bank Number of the memory bank where the image file will down-
load.