Filter
Top Products
Configuration
Page 3-34
Current Settings
Table 3-9 explains each setting on the Forwarding Database Configuration
Menu.
Table 3-9 Forwarding Database Configuration Menu settings
Displaying the Forwarding Database
Use the following procedure to view the Unicast Forwarding Database table.
1 Open the Unicast Forwarding Database Configuration
Menu by typing d in the Configuration Menu.
2 Type either a, p, or v, depending on the range of MAC
addresses you want to view.
Type a to display the MAC addresses of all ports on the
IntraCore 8000.
Type p to specify a port, then see the MAC addresses for
that port only.
Type v to specify a VLAN, then see the MAC addresses
for the member ports of that VLAN only.
3 At the prompt which appears, type y to see IP addresses
in the display or type n to see the display without IP
addresses, then press Return. The selected display
appears.
Examples of the Unicast Forwarding Database table are shown in Figure 3-
18 (all ports, without IP displayed) and Figure 3-19 (one port, without IP
displayed).
K Note: When the IP addresses are displayed, the age and
priority are not displayed, as shown in Figure 3-19.
Setting Description
Age-out Time The number of seconds that addresses are retained in the table.
The default is 300 seconds. The range is from 10 to 1,000,000.
MAC Address Count The number of entries currently in the MAC Address Table.
IP Address Count The number of entries in the MAC Address Table that contain a
corresponding IP address.