Filter
Top Products
2-23ASUS TS300-E5
2.9 Cable connections
Standard cables connected to the motherboard
1. 24-pin ATX power
2. 4-pin 12V power
3. CPU_FAN1 (connected to the cooler)
4. FRNT_FAN2 (connected to the 12cm Rear Fan)
5. Serial ATA connectors [connected to the SATA backplane (PA4 model only)]
6. Front USB cable (connected to the front panel)Front USB cable (connected to the front panel)
7. Front panel cable
8. Floppy disk drive
9. Primary IDE cable (connected to the optional drive)
10. Chassis Intrusion connector (connected to the rear chassis intrusion switch)
11. SMBus connector (connected to the backplane)
2.9.1 Motherboard connections
• The bundled system cables are pre-connected before shipment. You do
not need to disconnect these cables unless you will remove pre-installed
components to install additional devices.
• Refer to Chapter 4 for detailed information on the connectors.
24.5cm (9.6in)
30.5cm (12in)
DDR2 DIMM_A1 (64 bit,240-pin module)
DDR2 DIMM_A2 (64 bit,240-pin module)
DDR2 DIMM_B1 (64 bit,240-pin module)
DDR2 DIMM_B2 (64 bit,240-pin module)
Intel
Bigby-p MCH
Intel
ICH7R
ATX12V1
PCIE1
PCI3
PCIE4
PCIE2
PCI5
PCI6
Super I/O
8Mb
BIOS
SATA1
SATA3
SATA2
SATA4
PRI_IDE1
USB34
FRNT_FAN2
FRNT_FAN1
CPU_FAN1
FRNT_FAN3
CR2032 3V
Lithium Cell
CMOS Power
AUX_PANEL1
PANEL1
FLOPPY1
COM2
SB_PWR1
CLRTC1
RECOVERY1
CPUFAN_SET1
CHAFAN_SET1
ATXPWR1
®
P5BP-E/4L
PS/2KBMS
T: Mouse
B: Keyboard
LAN_USB12
LAN1_LAN2
VGA1
COM1
LAN3_LAN4
LGA775
BCM
5721
BCM
5721
BCM
5721
ISL
6312
XGI
Z9s
BUZZ1
CMI9880
ASMB3
RAID_SEL1
BCM
5721
REAR_FAN1
HDLED1
1
1
2
3
4
5
6
7
8
9
10
11