Filter
Top Products
Chapter 2: Hardware setup2-30
2.10.2 HDD blower (optional)
To remove the HDD blower:
1. Remove the side cover. Refer to
section 2.1.1 Removing the side
cover for instructions.
2. Disconnect the 3-pin fan cable from
the fan connector on the backplane.
4. Firmly grip the blower case as
shown, then slide it out of the
chassis in the direction of the arrow
until the tabs are released from the
holes of the HDD cage.
3. Loosen the thumb screw that
secures the HDD blower case to
the chassis.
4. Plug the system fan cable to the
connector FRNT_FAN2 on the
motherboard.