Filter
Top Products
Chapter 2: Hardware setupChapter 2: Hardware setup
Chapter 2: Hardware setupChapter 2: Hardware setup
Chapter 2: Hardware setup
2-162-16
2-162-16
2-16
7. Make sure that the drive and
bay holes align as shown. When
in place, the drive protrudes
about an inch from the front
panel.
8. Pull down the bar lock and insert
the lock pegs to the drive/bay
holes, then push the drive lock
to the right to secure the drive.
9. On the front panel assembly, detach the plastic bay cover opposite
the 5.25-inch drive that you installed by pressing the two hooked tabs
on each side of the bay cover.
10. Reinstall the front panel assembly when done. Refer to section “2.5.2
Reinstalling the front panel assembly” for instructions.