Filter
Top Products
Chapter 2: Hardware setupChapter 2: Hardware setup
Chapter 2: Hardware setupChapter 2: Hardware setup
Chapter 2: Hardware setup
2-422-42
2-422-42
2-42
2.10.72.10.7
2.10.72.10.7
2.10.7
Power suppy unitPower suppy unit
Power suppy unitPower suppy unit
Power suppy unit
Refer to this section when removing or installing power supply modules to
the barebone system.
You MUST disconnect all power cable plugs from the motherboard and
other installed devices before removing the power supply unit.
The picture below shows the motherboard and device connectors where
the power plugs are connected. Refer to the Appendix at the end of this
document for the power supply specifications.
1. 24-pin ATX (motherboard power connector;
hidden behind the drive cage
)
2. 8-pin +12V (motherboard power connector;
hidden behind the drive cage
)
3. 2 x 4-pin plugs (SATA backplane)
4. 4-pin plug (floppy disk drive;
hidden
)
44
44
4
33
33
3
11
11
1
22
22
2
Make sure to unplug
ALL ALL
ALL ALL
ALL power cables from the system devices before
removing the power supply module.