Filter
Top Products
CM1164 RS-232 Control Tool
15
Port Disable
The Port Disable command allows you to disable a ports display from being
shown. Use the Formula - to set Parameters - to create a Command.
Formula:
Command + Control + Control + [Enter]
Parameters:
Port Disable Commands
Some available formulas for Disable Port commands are as follows:
1. Command + Control + Control + [Enter]
For example, to set disable the video output of port 4, type the following:
chn p4 on [Enter]
2. Command + Control + Control + [Enter]
For example, to set enable the video output of port 1, type the following:
chn p1 off [Enter]
Note: Each command string can be separated with a space.
Command Description
chn Port Disable Command
Control Description
px Disable video out of port number, x= 1~4
Example: p3
on Disable channel display
off Enable channel display
Enter Description
Enter Enter and send out command