Filter
Top Products
CM1164 RS-232 Control Tool
9
Switch Port
The switch port command allows you to switch between computers connected
to the CM1164’s ports. Use the Formula - to set Parameters - to create a
Command.
Formula:
Command + Input Command + [Enter]
Parameters:
Switch Port Commands
Some available formulas for the Switch Port commands are as follows:
1. Command + Input Command + [Enter]
For example, to switch to port 2, type the following:
sw p2 [Enter]
2. Switch Command + Input Command + [Enter]
For example, to switch to port 4, type the following:
sw p4 [Enter]
Note: 1. Each command string can be separated with a space.
2. The Port Number command string can be skipped, and the default
value will be used.
Command Description
sw Switch Port Command
Input Command Description
px Input port number,
x= 1~4 (Default: 1)
Example: p2
Enter Description
Enter Enter and send out command