Filter
Top Products
CM1164 RS-232 Control Tool
8
Open/Close RS-232 Link
The Open/Close RS-232 Link command allows you to open/close the link
between the computer sending RS-232 commands and the CM1164. When the
link is “open” the CM1164 only accepts RS-232 commands and will not
respond to front panel pushbuttons, hotkeys, OSD, or remote control
commands - until the link is closed. The link opens when you login and closes
after 2 minutes if no command is sent. Use the Formula - to set Parameters -
to create a Command.
Formulas:
Command + [Enter]
Parameters:
Open/Close RS-232 Link Command
The available formulas for the Open/Close RS-232 Link commands are as
follows:
1. Command + [Enter]
For example, to open the RS-232 Link between the computer and CM1164,
type the following:
open [Enter]
2. Command + [Enter]
For example, to close the RS-232 Link between the computer and CM1164,
type the following:
close [Enter]
Command Description
open Open RS-232 Link Command
close Close RS-232 Link Command
Enter Description
Enter Enter and send out command