Filter
Top Products
CM1164 RS-232 Control Tool
20
Port ID Display
The Port ID Display command allows you to change the port ID numbers
displayed for each port. Use the Formula - to set Parameters - to create a
Command.
Formulas:
Command + Control + [Enter]
Set Port ID and Display Duration:
Command + Control + Number + [Enter]
Parameters:
Port ID Display Commands
Some available formulas for Port ID Display commands are as follows:
1. Command + Control + [Enter]
For example, to set all port ID’s to the factory default, type the following:
portid default [Enter]
2. Command + Control + Number + [Enter]
For example, to change port 4’s ID number to 37, type the following:
portid p437 [Enter]
(Continues on next page.)
Command Description
portid Port ID Display Command
Control Description
pxxx Change port, x= 1~4 (Port Number)
xx= 1~99 (New Port Number)
Example: p478
default Reset all port ID’s to the factory default
txx Set ID display duration, xx= 1~99 seconds
Example: t55
Enter Description
Enter Enter and send out command