Filter
Top Products
CM1164 RS-232 Control Tool
29
Hardware Cursor
The Hardware Cursor command allows you to enable/disable the hardware
cursor feature. Use the Formula - to set Parameters - to create a Command.
Formulas:
Command + Control + [Enter]
Parameters:
Hardware Cursor Commands
Some available formulas for Hardware Cursor commands are as follows:
1. Command + Control + [Enter]
For example, to enable the hardware cursor, type the following:
hc on [Enter]
2. Command + Control + [Enter]
For example, to disable the hardware cursor, type the following:
hc off [Enter]
Note: Each command string can be separated with a space.
Command Description
hc Hardware Cursor Command
Control Description
off Disable the hardware cursor
on Enable the hardware cursor
Enter Description
Enter Enter and send out command