Filter
Top Products
37
ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual
4.5.4 Serial Port Configuration Commands
The serial port configuration may be customized by using the following commands:
SerialPortBaudRate
Sets the baud rate the Diamond Storage Array uses for its
terminal interface.
Choices: 2400, 9600, 19200, 38400, 57600, 115200
Default: 115200
Set syntax: set SerialPortBaudRate [2400 | 9600 | 19200
| 38400 | 57600 | 115200]
Get syntax: get SerialPortBaudRate
SerialPortEcho
Controls whether the Diamond Storage Array echoes
characters on its RS-232 port. Local ASCII terminal (or
terminal emulator) echo settings should be set to disabled
while in serialportecho enabled
Default: disabled
Set syntax: set SerialPortEcho [enabled | disabled]
Requires a SaveConfiguration Restart command
Get syntax: get SerialPortEcho
SerialPortHandshake
Describes which handshaking method the Diamond
Storage Array uses for its terminal interface (hardware,
Xon/Xoff or none).
Choices: hardware, Xon or none
Default: none
Set syntax: set SerialPortHandshake [hard| Xon| none]
Requires a SaveConfiguration Restart command
Get syntax: get SerialPortHandshake
SerialPortStopBits
Configures/reports the number of stop bits per character
for the Diamond Storage Array RS -232 serial port. The
number of data bits per character is fixed at 8 with no
parity.
Choices: 1 or 2
Default: 1 stop bit
Set syntax: set SerialPortStopBits [1 | 2]
Requires a SaveConfiguration Restart command
Get syntax: get SerialPortStopBits