Filter
Top Products
84 DSR Switch Installer/User Guide
There are two ways to remove the certificate from the DSR switch.
• The certificate will be automatically removed if you remove the DSR switch from the DSView
3 software database. This enables you to move the DSR switch from one certificate replication
system to another.
• The Unbind option will also allow you to remove the certificate from the DSR switch, enabling
you to move the DSR switch from one certificate replication system to another. After the
Unbind option is used, any server running DSView 3 software will be able to communicate
with the DSR switch. All authentication server addresses will be cleared.
See the DSView 3 Installer/User Guide for more information on software security.
Firmware Management
This menu contains the Flash Download selection. For more information, see Flash Upgrades
section on page 85.
Enable Debug Messages
This menu option turns on console status messages. Because this can significantly reduce
performance, you should only enable debug messages when instructed to do so by Avocent
Technical Support. When you are finished viewing the messages, press any key to exit this mode.
Restore Factory Defaults
This menu option will restore all switch options to the default settings.
Reset Appliance
This menu option allows you to execute a soft reset of the DSR switch.
Exit
This menu selection will return you to the ready prompt. If the Console menu interface password is
enabled, you must exit the Console Main menu so that the next user will be prompted with the
Username and Password login screen.