Filter
Top Products
16. Servicing
6. Turn out the third lid using the back of the main lid. (image 16-14)
7. Top-up the reservoir with cooling liquid until the level is somewhat higher than the hole in the reservoir. (image 16-15)
8. Close the third lid again using the back of the main lid. Use a cloth to dab the residue of cooling liquid.
Note: Make sure that no cooling liquid is spilled in the projector.
9. Turn in the bleed lid.
10.Close the main lid.
11.Pressurize the circuit by turning the bolt to the left until there is 2 cm free threat between the bolt and the bottom of the reservoir
(the white indication line should be in the good area). (image 16-16)
Reinstall all projector covers :
- side cover, see "Installation of the side cover", page 185.
- top cover, see "Installation of the top cover", page 186.
- back cover, see "Installation of the back cover", page 186.
- front cover, see "Installation of the front cover", page 187.
- lamp door, see "Installation of the lamp door", page 188.
A
B
Image 16-13
Open reservoir
CD
Image 16-14
Remove third lid
178 R59770021 CLM R10+ 11/10/2010