Filter
Top Products
5. Connections
DMX is used as communication bus between different devices in the light technic. Each device has an input and an output, so that
the bus can be looped between the different devices. According the standard a five wire cable with XLR connector is used but mostly
3-wire cables are used.
You can use the DMX input port (G) to connect a DMX device to the CLM projector. This way you can control the CLM projector
from that DMX device. The DMX output port (G) can be connected with the next device in the loop.
Pin Description
1Earth
2Cold
3Hot
4 Return - (or not used)
5
Return + (or not used)
DMX
DMX-512 Lighting protocol over RS-485 interface. Carries information of 512 channels from a lighting controller to
lighting devices. Standardized by USITT.
R59770021 CLM R10+ 11/10/2010 45