Filter
Top Products
x
Wiring Information (For U.K. only)
Important
If the mains plug supplied with this printer is not suitable for your socket outlet, remove the
plug from the mains cord and fit an appropriate three pin plug. If the replacement plug is
intended to take a fuse then fit the same rating fuse as the original.
If a moulded plug is severed from the mains cord then it should be destroyed because a plug
with cut wires is dangerous if engaged in a live socket outlet. Do not leave it where a child
might find it!
In the event of replacing the plug fuse, fit a fuse approved by ASTA to BS1362 with the same
rating as the original fuse.
Always replace the fuse cover. Never use a plug with the cover removed.
WARNING - THIS PRINTER MUST BE PROPERLY EARTHED.
The wires in the mains cord are colored in accordance with the following code:
Green and yellow: Earth
Blue: Neutral
Brown: Live
The colors of the wires in the main lead of this printer may not correspond with the colored
markings identifying the terminals in your plug.
If you need to fit a different plug, proceed as follows.
Remove a length of the cord outer sheath, taking care not to damage the colored insulation
of the wires inside.
Cut each of the three wires to the appropriate length. If the construction of the plug permits,
leave the green and yellow wire longer than the others so that, in the event that the cord is
pulled out of the plug, the green and yellow wire will be the last to disconnect.
Remove a short section of the colored insulation to expose the wires.
The wire which is colored green and yellow must be connected to the terminal in the plug
which is marked with the letter “E” or by the safety earth symbol
or colored green or green
and yellow.
The wire which is colored blue must be connected to the terminal which is marked with the
letter “N” or colored black or blue.
The wire which is colored brown must be connected to the terminal which is marked with the
letter “L” or colored red or brown.
The outer sheath of the cord must be secured inside the plug. The colored wires should not
hang out of the plug.