Filter
Top Products
6-21
Message Meaning and Action
Push in
the Tray
None of the trays are properly inserted.
Action:
Push the all paper trays completely back into the printer.
Empty
Exit Tray
The face down tray is full.
Action:
Remove the paper from the face down tray.
Replace Black
Toner (K)
The black toner cartridge is empty.
Action:
Replace the black toner cartridge.
See 8.1.2 “Replacing the Toner Cartridges”
Reinsert Black
Toner (K)
There is no black toner cartridge inserted in the printer or the
cartridge is improperly set.
Action:
Grip the levers at each end of the black toner cartridge with your
fingers, then push down firmly to rotate the levers forward to
install the cartridge.
See 8.1.2 “Replacing the Toner Cartridges”
Operation Error
Please Press Set
The request from the computer could not be printed.
Action:
Press the <Form Feed/Set> button and cancel printing. Check
the printer driver settings and reprint.
Operation Denied
While Printing
An illegal operation was performed on the control panel during
printing.
Wait until printing finishes.
ServCallJ1 This is a warning message. Contact your dealer or Brother
authorized service representative.
Close
Front Cover
The front cover is open.
Action:
Make sure that the front cover is properly closed.
Replace Magenta
Toner (M)
The magenta toner cartridge is empty.
Action:
Replace the magenta toner cartridge.
See 8.1.2 “Replacing the Toner Cartridges”
Reinsert Magenta
Toner (M)
There is no magenta toner cartridge inserted in the printer or the
cartridge is improperly set.
See 8.1.2 “Replacing the Toner Cartridges”
Out of Memory
Please Press Set
There is not enough memory available for the printer to function
normally.
Action:
Press the <Form Feed/Set> button and cancel printing. Install a
memory expansion card and reprint.
See Appendix A.5 “Adding the Expansion Memory”.
If you are unable to install a memory expansion card, print after
configuring the printer driver as follows:
• Turn off the Duplex Printing and Multiple Page setting.
• Change the setting in ‘Document Types’ to ‘Normal’ in the
“Graphics” tab (Windows), or the “General” dialog box
(Macintosh). Note that this lowers image quality.
See “Help”