Cabletron Systems 2208 Switch User Manual


 
Chapter 5: Local Management
Page 5-60 2H22-08R SmartSwitch 2208 User’s Guide
5.15.2 Changing Source and Destination Ports
Add or delete source port and destination port entries as follows:
1. Use the arrow keys to highlight the Source Port field.
2. Press the SPACE bar or BACKSPACE one or more times to increment
or decrement the port number displayed in the brackets [n] until the
appropriate port number displays.
3. Use the arrow keys to highlight the Destination Port field.
4. Use the SPACE bar or BACKSPACE to step to the appropriate port
number for the destination port.
5. Use the arrow keys to highlight the Status field.
6. Use the SPACE bar to select either the [ADD] or [DEL] (delete)
option. Press ENTER. This adds or deletes the port selections made in
steps 2 and 4 and also updates the screen Source Port and Destination
Port list.
7. Use the arrow keys to highlight the Errors field.
8. Use the SPACE bar to select either the [ON] or [OFF] option and
press ENTER. [ON] forces the source device and port to forward
errored frames to the destination device(s) and port(s). [OFF] forces
the errored to be dropped before forwarding traffic.
9. Use the arrow keys to highlight SAVE at the bottom of the screen.
Press ENTER. The message “SAVED OK” displays. This saves the
new settings and updates the Source Interface and Destination
Interface read-only fields.
NOTE
If more than one port is to be redirected, repeat steps 1 through
8 for each additional setting, then go to step 9 to save all the
new settings at once.