Filter
Top Products
Removing the Chassis Cover
2H22-08R SmartSwitch 2208 User’s Guide Page C-3
To remove the chassis cover, proceed as follows:
1. Disconnect all network cables attached to the 2H22-08R.
2. If the 2H22-08R is rack mounted, remove it from the rack and remove
the rackmount brackets (refer to Chapter 3).
3. Use a Phillips screwdriver to remove the screws attaching the cover to
the chassis. (See Figure C-1.)
4. Remove the cover by sliding it back until it clears the front of the
chassis and then lifting it straight up and off the chassis.
TURN OFF THE 2H22-08R BY UNPLUGGING BOTH POWER
CORDS FROM THE REAR OF THE CHASSIS.
AM HINTEN DES 2H22-08R STECHEI ABZIEHEN UM AUS
ZU SCHALTEN.
APAGUE EL 2H22-08R DESENCHUFE EL CABLE DE LA
UNIDAD.
TIP
Before performing step 1, mark the cables connected to the
2H22-08R according to their associated port numbers. This is
recommended for ease of reinstallation.