Filter
Top Products
Device Configuration Menu Screen
2H22-08R SmartSwitch 2208 User’s Guide Page 5-15
The following briefly explains each screen accessible from the Device
Configuration Menu screen:
GENERAL CONFIGURATION
The General Configuration screen allows you to monitor and configure
operating parameters for the 2H22-08R. For details, refer
to Section 5.7.
SNMP COMMUNITY NAMES
The SNMP Community Names screen allows you to enter new, change,
or review the community names used as access passwords for device
management operation. Access is dependent on a user’s password level.
For details, refer to Section 5.8.
SNMP TRAPS
The SNMP Traps screen provides display and configuration access to the
table of IP addresses used for trap destinations and associated community
names. For details, refer to Section 5.9.
SWITCH CONFIGURATION
The Switch Configuration screen provides the basic setup options for
making a switch operational in the network. For details, refer to
Section 5.10.
ETHERNET INTERFACE CONFIGURATION
The Ethernet Interface Configuration screen indicates the link status,
current and desired operational mode, and advertised ability for ports 1
through 8 on the 2H22-08R. Refer to Section 5.11 for details.
SMARTTRUNK CONFIGURATION
The SmartTrunk Configuration screen allows the user to logically group
interfaces together to aggregate high speed uplinks. Refer to the
Cabletron Systems SmartTrunk User’s Guide for additional information.
DEVICE SPECIFIC CONFIGURATION
The Device Specific Configuration menu screen allows you to select
screens to configure ports or check system resources specific to the
2H22-08R. For details, refer to Section 5.12.