Filter
Top Products
Chapter 5: Local Management
Page 5-54 2H22-08R SmartSwitch 2208 User’s Guide
The following briefly explains each field of the Flash Download screen:
Download Method (Selectable)
This field steps to BOOTP, TFTP, and RUNTIME. If set for BOOTP,
the 2H22-08R sends out a BootP request to determine the IP address of
the TFTP server and the File Name of the image to be downloaded. If set
for TFTP or RUNTIME, the 2H22-08R attempts a TFTP download based
on the IP address and filename entered in the fields at the bottom of the
Flash Download screen. Section 5.14.1 describes downloading using
BootP. Section 5.14.2 describes how to download using TFTP.
Section 5.14.3 describes downloading using RUNTIME.
Reboot After Download (Modifiable only when RUNTIME is chosen)
This field notifies you that the 2H22-08R reboots after the download is
complete. If a RUNTIME Download is performed, this field toggles
between YES and NO. If YES is selected, the 2H22-08R reboots after the
download completes. If NO is selected, the device continues using the
existing the firmware image and stores the new firmware image in
FLASH memory. When the device is reset or during the next power-up,
the device boots from FLASH memory using the new image.
TFTP Gateway IP Addr (Selectable)
This field shows the IP address of the TFTP gateway server defined in the
General Configuration screen in Section 5.7.4.
Last Image Server IP (Read-only)
This field shows the IP address of the server used for the previous FLASH
Download.
Last Image File Name (Read-only)
This field shows the complete path and file name of the last image
downloaded to FLASH.
If TFTP or RUNTIME are selected as the download method (see
Figure 5-21), the following two additional fields display:
Download Server IP (Selectable)
Enter the IP address of the TFTP server to be used for the FLASH
download.