Filter
Top Products
Connecting to the Network
2H22-08R SmartSwitch 2208 User’s Guide Page 3-9
Connect an FE-100TX to a Twisted Pair segment as follows:
1. Ensure that the device connected to the other end of the segment is
powered on.
2. Connect the twisted pair segment by inserting the RJ45 connector into
the RJ45 port on the module shown in Figure 3-8.
Figure 3-8 FE100-TX Port
3. Verify that a link exists by checking that the port RX LED is on
(flashing amber, blinking green, or solid green). If the RX LED is off
and the TX LED is not blinking amber, perform the following steps
until the RX LED is on:
a. Verify that the 100BASE-TX device at the other end of the twisted
pair segment is powered up.
b. Verify that the RJ45 connector on the twisted pair segment has the
proper pinouts.
c. Check the cable for continuity.
TX LED
RJ45
RX LED
FE-100TX
10
100
x
=
8
7