Filter
Top Products
Chapter 5: Local Management
Page 5-36 2H22-08R SmartSwitch 2208 User’s Guide
The following explains each field of the SNMP Traps screen.
Trap Destination (Modifiable)
Indicates the IP address of the workstation to receive trap alarms. Up to
eight different destinations can be defined as described in Section 5.9.1.
Trap Community Name (Modifiable)
Indicates the Community Name included in the trap message sent to the
Network Management Station with the associated IP address to change
the community name, refer to Section 5.9.1.
Enable Traps (Toggle)
Allows transmission of the traps to the network management station with
the associated IP address. This field toggles between YES and NO as
described in Section 5.9.1.
5.9.1 Configuring the Trap Table
To configure the Trap table, proceed as follows:
1. Use the arrow keys to highlight the appropriate Trap Destination
field.
2. Enter the IP address of the workstation that is to receive traps. IP
address entries must follow the DDN format.
For example: 134.141.79.121
3. Press ENTER. If an invalid entry is entered, the message “INVALID
IP ENTERED” displays.
4. Use the arrow keys to highlight the Trap Community Name field.
Enter the community name.
5. Press ENTER.
6. Use the arrow keys to highlight the Enable Traps field. Press the
SPACE bar to choose either YES (send alarms from the 2H22-08R to
the workstation), or NO (prevent alarms from being sent).
7. Use the arrow keys to highlight the SAVE command and press
ENTER. The message “SAVED OK” displays.