Filter
Top Products
General Configuration Screen
2H22-08R SmartSwitch 2208 User’s Guide Page 5-27
5.7.10 Configuring the COM Port
Upon power up, the COM port is configured to the default settings of
ENABLED and LM.
To configure the COM port, you must enable/disable the COM port and
select an application.
The 2H22-08R COM port supports the following applications:
• Local Management connections
• American Power Conversion Uninterruptible Power Supply (UPS)
connections
1. Use the arrow keys to highlight the Com field.
NOTE
Upon saving the new Operational Mode, the module reboots.
If the 2H22-08R has been set to 802.1Q SWITCHING, refer to
your Port Based VLAN User’s Guide to configure the devices
for this type of operation.
If the 2H22-08R has been set to SECURE FAST VLAN, refer to
your SecureFast documentation set to configure the devices for
this type of operation.
!
CAUTION
Before altering the COM port settings, read this entire COM
port configuration section. Altering the COM port settings
disconnects the Local Management terminal from the port, and
ends the Local Management session.