Filter
Top Products
Removing the Chassis Cover
2H28-08R SmartSwitch 2208 User’s Guide C-3
2. If the 2H28-08R is rack mounted, remove it from the rack and remove
the rackmount brackets (refer to Chapter 3, Optional Installations
and Mode Switch Bank Settings).
3. Use a Phillips screwdriver to remove the screws attaching the cover to
the chassis. (See Figure C-1.)
4. Remove the cover by sliding it back until it clears the front of the
chassis and then lifting it straight up and off the chassis.
To reinstall the chassis cover, perform the removal procedures in reverse.
Figure C-1 Removing the Chassis Cover
2251-30
Chassis Cover
Chassis
Cover Screws (7)
Note: If the device was rack mounted, the four screws fastening the cover to
the front panel are removed and installed along with the rackmount brackets.
Front Panel