Filter
Top Products
General Configuration Screen
2H28-08R SmartSwitch 2208 User’s Guide 5-17
Figure 5-9 General Configuration Screen
The following briefly explains each General Configuration screen field:
MAC Address (Read-Only)
Displays the base physical address of the 2H28-08R.
IP Address (Modifiable)
Displays and allows the user to set the IP address for the 2H28-08R. To
set the IP address, refer to Section 5.7.1. The IP address can also be set
through Runtime IP Address Discovery as previously described in
Section 1.3.5.
Subnet Mask (Modifiable)
Displays the subnet mask for the 2H28-08R. A subnet mask “masks out”
the network bits of the IP address by setting the bits in the mask to 1 when
the network treats the corresponding bits in the IP address as part of the
network or subnetwork address, or to 0 if the corresponding bit identifies
the host. Once an IP address has been entered, the device will
automatically generate and display a default subnet mask based on the
entered IP address. For details about changing the subnet mask from its
default value, refer to Section 5.7.2.
Firmware Revision: XX.XX.XX
General Configuration
2286-15
Device Type: 2H28-08R
BOOTPROM Revision: XX.XX.XX
MAC Address:
IP Address:
Subnet Mask:
Default Gateway:
TFTP Gateway IP Addr:
Device Date:
Device Time:
Screen Refresh Time:
Screen Lockout Time:
Device Uptime: XX D XX H XX M
Com 1: [ENABLED] Application: [LM]
Clear NVRAM: [NO]
Operational Mode: [802.1D SWITCHING]
2H28-08R LOCAL MANAGEMENT
Event Message Line
RETURNSAVE
00-00-ID-00-00-00
0.0.0.0
0.0.0.0
NONE DEFINED
0.0.0.0
11/11/1997
14:23:00
03 sec.
15 min.
EXIT