Filter
Top Products
Chapter 2: Network Requirements
2-2 2H28-08R SmartSwitch 2208 User’s Guide
2.2 100BASE-FX FIBER OPTIC NETWORK
Ports 1 through 6 of the 2H28-08R support the multimode 100BASE-FX
interface. Ports 7 and 8 of the 2H28-08R support the Cabletron Systems
FE-100FX and FE-100F3 fiber optic interface modules. The FE-100FX is
designed for use with multimode fiber optic cable, while the FE-100F3 is
designed for use with single mode fiber optic cable.
The device at the other end of the fiber optic segment must meet the
100BASE-FX Fast Ethernet network requirements to operate at
100 Mbps.
Multimode Fiber Optic Cable Length
The multimode fiber optic cable specifications for a 100BASE-FX
segment is covered in the Cabletron Systems Cabling Guide.
Single Mode Fiber Cable Lengths
With the installation of an optional FE-100F3, single mode fiber optic
cable may be used to make a connection to a similar device at the other
end of the fiber. The maximum single mode fiber optic length of a
100BASE-FX segment may be no more than 5 km between Data
Terminal Equipment (DTE to DTE) in half duplex mode or 20 km (DTE
to DTE) in full duplex mode. Refer to Appendix B for more information
on single mode fiber cable.
NOTE
The 2H28-08R has six SC fiber optic ports designed for use
with multimode fiber. Use of incorrect cabling may cause
network problems.