Filter
Top Products
Chapter 5: Local Management
5-22 2H28-08R SmartSwitch 2208 User’s Guide
3. Press ENTER. If the subnet mask is valid, the cursor returns to the
beginning of the Subnet Mask field. If the entry is not valid, the screen
displays the message “INVALID SUBNET MASK OR FORMAT
ENTERED”. Local Management does not alter the current value, but
it does refresh the Subnet Mask field with the previous value.
4. Use the arrow keys to highlight the SAVE command. The warning
screen shown back in Figure 5-10 displays.
5. Use the arrow keys to highlight the YES command and press ENTER.
The changes are saved and the module reboots.
5.7.3 Setting the Default Gateway
If the SNMP management station is located on a different IP subnet than
the 2H28-08R, a default gateway must be specified. When an SNMP trap
is generated, the 2H28-08R sends the trap to the default gateway. To set
the default gateway, perform the following steps:
1. Use the arrow keys to highlight the Default Gateway field.
2. Enter the IP address of the default gateway using the DDN format.
For example: 134.141.79.121
3. Press ENTER. If the default gateway entered is a valid format, the
cursor returns to the beginning of the Default Gateway field. If the
entry is not valid, the screen displays “INVALID DEFAULT
GATEWAY OR FORMAT ENTERED”. Local Management does not
alter the current value, but it does refresh the Default Gateway field
with the previous value.
4. Use the arrow keys to highlight the SAVE command.
5. Press ENTER. The message “SAVED OK” displays at the top of the
screen.