Cabletron Systems 2H28-08R Switch User Manual


 
Chapter 5: Local Management
5-36 2H28-08R SmartSwitch 2208 User’s Guide
5.10 SWITCH CONFIGURATION SCREEN
The Switch Configuration screen, Figure 5-16, provides the basic setup
options to make a switch operational in your network.
To access the Switch Configuration screen from the Device Configuration
Menu screen, use the arrow keys to highlight the SWITCH
CONFIGURATION menu item and press ENTER. The Switch
Configuration screen displays showing Ports 1 through 6. The optional
ports, 7 and 8, will display also if Fast Ethernet Interface Modules are
installed.
Figure 5-16 Switch Configuration Screen
NOTE
The Switch Configuration screen will not be available if the
operational mode of the module has been set to SECURE
FAST VLAN. This screen may only be used by modules
configured to operate as traditional or 802.1Q switches.
Firmware Revision: XX.XX.XX
Switch Configuration
2286-18
Device Type: 2H28-08R
BOOTPROM Revision: XX.XX.XX
Port #
1
2
3
4
5
6
7
8
State
learning
disabled
blocking
disabled
listening
disabled
forwarding
forwarding
2H28-08R LOCAL MANAGEMENT
Event Message Line
RETURNSAVE
MAC Address
00-00-1D-00-00-00
00-00-1D-00-00-01
00-00-1D-00-00-02
00-00-1D-00-00-03
00-00-1D-00-00-04
00-00-1D-00-00-05
00-00-1D-00-00-06
00-00-1D-00-00-07
Status
[ENABLED]
[DISABLED]
[ENABLED]
[DISABLED]
[ENABLED]
[DISABLED]
[ENABLED]
[ENABLED]
Switch Address: 00-00-1D-00-00-00
Number of Ports: 8
Type of STA: [DEC]
Age Time (sec): 300
EXIT