Filter
Top Products
Menu Settings Summary Tables
13
5-13
Paper Adjust
Plain Paper, Coated Paper, Photo
Pro, Glossy Paper, Glossy Paper 2,
Matte Photo, Glossy Film, Quick
Dry Tran, Transparency, Special 1
~
Special 5, Proof A
~
Proof D
Print Pattern A, Print Pattern B,
Adj. Setting
:-28
~
0*
~
+28
Use this menu to adjust the amount
of feed for type of the media. If the
printed image of “Pattern A” has
white streaks or dark streaks, set the
adjustment value. For fine
adjustment, print “Pattern B” and
select the adjustment value.
Set Interface
Interface Type Centronics, USB*
Allows selection Centronics for a
parallel interface connection or USB
for a USB connection.
Set Centronics
Trans. Speed
High Speed*, Medium Speed,
Low Speed
Allow selections for speed and
format of bi-directional printing. A
hard reset must be performed on the
printer to enable these settings.
Interactive ECP*, Nibble, None
Ext. Network
Init. Settings
Executes the initial settings for the
“Ext. Network” menu.
Set TCP/IP
Frame Type:
Disable, Ethernet II
IP Mode: Manual*, Automatic
Protocol
DHCP: On*, Off
BOOTP: On*, Off
RARP: On*, Off
IP Setting
IP Address
Subnet Mask
Default G/W
Allows selections to set up the TCP/
IP network information for the
network interface board. After
selecting a setting for each TCP/IP
item, execute “Regis. Settings” to
enable the values selected.
Regis. Settings
Registers the TCP/IP settings
selected above for the network
interface board.
Maint. Setup
Cleaning at ON On*, Off
Determines whether or not the
printhead is cleaned when the printer
is powered on.
*1
Panel Reset
Panel Reset
Initializes the operation panel menus
and restores the default settings. A
panel reset does not affect the “Ext.
Network” settings.
*1. If the date and time setting of the computer where the printer is connected are
not correct, the printhead may clean itself too frequently and waste ink. Make
sure that all the date and time settings on the computer are correct.
Menu Item Available Settings Functions