Filter
Top Products
72
Adjusting the Orientation of
Preview Images
The image in the display can be rotated 90 degrees without physically shifting
the object on the object stage.
!!! Important !!!
• The purpose of this command is to change the orientation of the image
on a computer display. This function has no direct effect upon the image
signal from the DZ-3600U.
• To place a document that will be reoriented with this function, place
the top edge on the right of the object stage.
••• Note •••
• We will illustrate placement using an A4-sized document, which is longer
than it is wide. Assuming that you would normally place this page on the
object stage vertically (correct orientation), a portion of the page will
protrude beyond the camera’s field on the vertical axis. If, instead, you
place it on its side (horizontal or landscape orientation) and use the rotate
function to shift the image 90 degrees, the entire page will fit into the
camera’s field.
• The image is captured with the orientation set by this command.
Procedure with the Remote Control
Rotating the
Display 90
Degrees
Press the [Rotate] button.
• The image will rotate 90 degrees
counterclockwise in the display,
appearing to be vertically
aligned.
• Pressing the [Rotate] button
again restores the image to its
original orientation.
APP REV FWD
ROTATE
Preview
Mode