Filter
Top Products
79
3
An Introduction to the Features
Shooting Negatives
To view negative films, turn on the backlight and switch to negative mode.
Ensure that the backlight is lit (P.77).
Procedure with the Remote Control
This function cannot be controlled with the remote control.
Procedure with the Control Panel
To Switch to Negative
Mode
Press the [NEGA] button.
• The mode will switch between the positive
and negative mode each time the button is
pressed.
• The indicator will light up in negative mode.
Procedures Required for showing Negative Films
1. Press the [NEGA] button and then place the negative film strip in
the center of the backlit object stage.
2. Zoom up on the desired frame until it fills the window.
3. Press the white balance [Auto] button on the control panel.
The auto indicator will shut off.
4. Press the white balance [Auto] button again after you have
finished viewing the frame.
The auto indicator will light and the auto white balance function will
be reactivated.
Procedure with a Computer
This function cannot be controlled from a computer.
SOFT HARD
RED BLUE
MANUALAUTO
POWER
CAPTURE
RESOLUTION
PREVIEW
WHITE BALANCE
NEGA
DETAIL
Preview
Mode