Filter
Top Products
Print Quality Problems
6-20
Troubleshooting
6
White dust is attached to the printed transparencies.
Cause The transparencies were printed just after other type of paper was printed
continuously.
Remedy If you make continuous print on other type of paper before printing on
transparencies, the transparencies may come out with chipped paper attached.
In this case, wipe and remove the chipped paper with a soft cloth.
Print is partially hollowed out.
Cause 1 Proper paper is not being used.
Remedy Replace the paper with a type that can be used with this printer. (See "Paper
Requirements," on p. 2-2.)
Cause 2 Paper is damp.
Remedy Replace paper with an unpacked stack.
Cause 3 The drum in the toner cartridge has deteriorated.
Remedy Replace the toner cartridge with a new one. (See "Replacing the Toner
Cartridge," on p. 5-2.)
Paper curls.
Cause 1 Paper is damp.
Remedy Replace paper with an unpacked stack.
Cause 2 Proper paper is not being used.
Remedy Replace the paper with a type that can be used with this printer. (See "Paper
Requirements," on p. 2-2.)
Cause 3 Paper was delivered into the face-down delivery area.
Remedy If you are using paper that curls easily, change the paper delivery area to the
face-up delivery slot. (See "Paper Delivery Area," on p. 2-11.)
Cause 4 Paper is too thin.
Remedy Specify [Paper Type] to [Plain Paper L] in the printer driver.
In order to specify [Paper Type], open the [Page Setup] sheet.