Filter
Top Products
Chapter 3 Booting and Configuring the CSS
Using the Configuration Script
3-10
Cisco 11500 Series Content Services Switch Hardware Installation Guide
78-13884-03
Using the Configuration Script
The CSS initiates the configuration script automatically when you log in and it
does not detect an existing startup-config file. During the configuration script, you
need to enter the following information:
• IP address and subnet mask for circuit VLAN1 (all interfaces are assigned to
VLAN1 by default)
• IP address for the default gateway
• IP addresses for the servers
• Virtual IP address (VIP) for the content rule
The configuration script allows you to create services, owners, and content rules
based on your entries and then enables you to:
• Configure Layer 3 load balancing
• Configure Layer 5 load balancing
• Configure Proxy cache
• Configure Transparent cache
• Exit from the script and save the information you entered to the
running-config
Note For information on services, owners, and content rules, refer to the Cisco Content
Services Switch Basic Configuration Guide.
To accept the script default values, press the Enter key at the prompts. To quit the
script, enter q at any prompt.
You may also initiate the configuration script manually by entering the
script play
setup
command.
To clear an existing running-config, use the
clear running-config command from
SuperUser mode. To clear an existing startup-config, use the
clear startup-config
command from SuperUser mode.
The following pages show you the entire configuration script including:
• Bold text to indicate where you enter information
• Explanations to help you use the script