Filter
Top Products
2-589
Catalyst 6500 Series Switch Command Reference—Release 8.6
OL-8977-01
Chapter 2 Catalyst 6500 Series Switch and ROM Monitor Commands
set port inlinepower
• limit—Discovery is enabled, and you can limit the power allocated for an external device. If the
wattage value that you specify with the limit keyword is less than the power that is specified by
IEEE classification, instead of denying power, the lesser of these two values is allocated. If the
device consumes more than the configured value, the port is shut down and a syslog message is
displayed. The limit keyword is supported only on modules with the WS-F6K-48-AF daughter card.
• off—Prevents the port from providing the power to an external device. If the external device is
wall-powered and inline power is off, the port should still link up, join the bridge group, and go to
the STP forwarding state.
Each port also has a status, defined as one of the following:
• on—Power is supplied by the port.
• off—Power is not supplied by the port.
• Power-deny—The supervisor engine does not have enough power to allocate to the port, or the
power that is configured for the port is less than the power that is required by the port; the power is
not being supplied by the port.
• err-disable—The port is unable to provide the power to the connected device that is configured in
Static mode.
• faulty—The port failed the diagnostics tests.
If you enter this command on a port that does not support the IP phone power feature, an error message
is displayed.
You can enter a single port or a range of ports, but you cannot enter the module number only.
Caution Damage can occur to equipment connected to the port if you are not using a phone that can be configured
for the IP phone phantom power feature.
Examples This example shows how to set the inline power to off:
Console> (enable) set port inlinepower 2/5 off
Inline power for port 2/5 set to off.
Console> (enable)
This example shows the output if the inline power feature is not supported:
Console> (enable) set port inlinepower 2/3-9 auto
Feature not supported on module 2.
Console> (enable)
Related Commands set inlinepower
show environment
show port inlinepower