Filter
Top Products
3-3
Cisco Global Site Selector 4491 Hardware Installation Guide
78-16356-01
Chapter 3 Installing the GSS
Installing Your GSS
Concurrently, report the nature and extent of the damage to Customer Service.
Report the problem or deficiency to Customer Service along with the model
number and serial number. Upon receipt of this information, you will be provided
with service instructions, or a Return Material Authorization (RMA) number and
shipping information. To obtain assistance, refer to the “Preface”.
Installing Your GSS
Place the GSS in the desired location. You can mount it in a rack for your
convenience, or place it on a solid, stable surface. If you do not plan to install the
GSS in an equipment rack, proceed to the “Installing the GSS on a Workbench or
Tabletop” section.
Racks are marked in vertical increments of 1.75 inches (4.44 cm). Each increment
is referred to as a rack unit (RU). A 1-RU device is 1.75 inches (4.44 cm) tall.
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must
take special precautions to ensure that the GSS remains stable. The following
guidelines are provided to ensure your safety:
This unit should be mounted at the bottom of the rack if it is the only unit in the
rack.
When mounting this unit in a partially filled rack, load the rack from the bottom
to the top with the heaviest component at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or
servicing the unit in the rack.
Statement 1006
This section contains the following procedures:
• Installing the GSS in a Four-Post Rack
• Attaching a Two-Post Rack Bracket to the GSS
• Installing the GSS on a Workbench or Tabletop