Filter
Top Products
Chapter 3 Installing the GSS
Removing or Replacing a GSS
3-20
Cisco Global Site Selector 4491 Hardware Installation Guide
78-16356-01
Removing or Replacing a GSS
Warning
Before working on a GSS, turn OFF the power and unplug the power cord.
Warning
Ultimate disposal of this product should be handled according to all national
laws and regulations.
Before physically removing or replacing a GSS, use the primary GSSM GUI to
logically remove the GSS from the network. You may need to logically remove a
GSS from your network when you:
• Move a GSS device between GSS networks
• Remove or replace a GSS or standby GSSM
• Send the GSS or standby GSSM out for repair or replacement
Table 3-2 Front Panel LED Indicators
Indicator Color State Indicates
1 Power Spike Blue On Normal operation
Blinking A power surge has occurred
2 Ethernet 0 Link Green On Ethernet 0 is connected to a network
Ethernet 0 Activity Green Blinking An active link connection on the
10/100/1000BASE-T interface for Ethernet port 0
3 Ethernet 1 Link Green On Ethernet 1 is connected to a network
Ethernet 1 Activity Green Blinking An active link connection on the
10/100/1000BASE-T interface for Ethernet port 1
4 Hard Drive Activity Green Blinking The hard drive is in use
5 Power Green On The GSS is on
Blinking The GSS is in standby mode