Filter
Top Products
Chapter 3 Installing the GSS
Connecting AC Power
3-16
Cisco Global Site Selector 4491 Hardware Installation Guide
78-16356-01
2. Connect the other end of the network cable to a hub or switch in your
network.
3. For console connections, plug the cable into the console port on the GSS back
panel.
4. Connect the other end of the console cable to a console or a
communications server.
Connecting AC Power
Warning
This equipment must be grounded. Never defeat the ground conductor or
operate
the equipment in the absence of a suitably installed ground conductor.
Contact
the appropriate electrical inspection authority or an electrician if you are uncertain
that suitable grounding is available.
Statement 1024
To connect AC power to your GSS:
1. Ensure that you have reviewed the safety information outlined in Chapter 2,
Preparing for Installation.
2. Plug the AC power cord into the power cord receptacle at the rear of the GSS
(see Figure 3-10).
3. Connect the other end of the power cord to a power source.
4. Power up all externally-connected devices.
5. Press the power control button on the front of the GSS.