Filter
Top Products
3-17
Cisco Global Site Selector 4491 Hardware Installation Guide
78-16356-01
Chapter 3 Installing the GSS
Booting the GSS
Booting the GSS
When you power up the GSS, the boot process:
• Performs hardware initialization and power-on self tests
• Initializes the BIOS
• Initializes the Linux boot manager, LILO (Linux Loader)
• Boots the GSS image (kernel and software)
• Displays the startup banner and splash screen for strong encryption
• Prompts you to log in to the GSS
Note During power-up, the green power LED on the front of the GSS is on.
At this point, you are ready to use the GSS. Refer to the:
• Cisco Global Site Selector Getting Started Guide for details on setting up and
configuring the GSS device
• Cisco Global Site Selector Administration Guide for procedures to properly
manage and maintain your GSSM and GSS devices
• Cisco Global Site Selector Global Server Load-Balancing Configuration
Guide for procedures to configure your GSS devices to perform global server
load balancing
If you are booting the GSS for the first time and it boots without a
startup-configuration file, a setup script automatically runs to guide you through
the process of initially configuring the GSS. Refer to the Cisco Global Site
Selector Getting Started Guide for details about using the setup script.