Filter
Top Products
Removing and Replacing Parts 4-35
6\VWHP%RDUG$VVHPEO\
)LJXUH6\VWHP%RDUG$VVHPEO\5HPRYDO
The system board assembly consists of the system board and a mounting
plate. The system board is held to the mounting plate with screws and mount-
ing clips.
To remove the system board assembly, follow these steps:
1. Disconnect all cables from the system board.
Be sure to record where each cable is attached.
2. To remove the system board tray, first release the tray latch at the lower-
back corner of the tray (see Figure 4-31) and pull the tray open to the
service position. Then depress the latch again and pull the tray out of the
chassis.
system
board tray
tray
latch