Filter
Top Products
System Setup Program A-1
$33(1',;$
6\VWHP6HWXS3URJUDP
This appendix describes the System Setup program, which is used to change
the system configuration information stored in NVRAM on the system board.
For in-depth information, refer to Chapter 4, “Using the System Setup Pro-
gram” in the
Dell PowerEdge 4300 Systems User’s Guide
.
To enter the System Setup program, follow these steps:
1. Turn on (or reboot) the system.
2. Press <Ctrl><Alt><Enter> immediately after you see the message 3UHVV
&WUO!$OW!(QWHU!IRU6\VWHP6HWXS.
If you wait too long, the operating system begins to load into memory, the
message disappears, and you cannot enter the System Setup program.
Let
the system complete the load operation
; then shut down the system and try
again.
NOTE: To ensure an orderly system shutdown, consult the documentation
that accompanied the operating system.