Filter
Top Products
Removing and Replacing Parts 4-37
*XLGH%UDFNHW$VVHPEO\
)LJXUH*XLGH%UDFNHW$VVHPEO\5HPRYDO
To remove the guide bracket assembly, follow these steps:
1. Remove the system board assembly.
2. Remove any terminator card, if necessary.
3. Remove any SEC cartridge and heat sink assembly, if necessary.
4. Loosen the four captive nuts that secure the guide bracket assembly to the
system board (see Figure 4-33).
5. Lift up the assembly and remove it from the four threaded posts.
guide bracket
assembly
captive nuts (4)
threaded posts (4)