Filter
Top Products
42 About Your System
Timer chip counter
2 failed
Faulty system board. See "Getting Help" on
page 167.
Unsupported CPU
combination
Microprocessor(s) is not
supported by the system.
Install a supported
microprocessor or
microprocessor
combination. See
"Processors" on page 105.
Unsupported CPU
stepping detected
Utility partition
not available
The <F10> key was
pressed during POST, but
no utility partition exists
on the boot hard drive.
Create a utility partition on
the boot hard drive. See the
CDs that came with your
system.
Warning! No micro
code update loaded
for processor 0
Micro code update failed. Update the BIOS firmware.
See "Getting Help" on
page 167.
Warning: Embedded
RAID firmware is
not present.
Embedded RAID firmware
does not respond.
See the RAID controller
documentation for
information about installing
or updating the RAID
firmware.
Warning: Embedded
RAID error.
Embedded RAID firmware
responds with an error.
See "Troubleshooting a SAS
Controller Daughter Card"
on page 147. See the RAID
controller documentation
for information about
installing or updating the
RAID firmware.
Table 1-7. System Messages (continued)
Message Causes Corrective Actions
Book.book Page 42 Monday, September 14, 2009 12:57 PM