Filter
Top Products
94 Installing System Components
5
Angle the DRAC card so that its NIC connector inserts through the back-
panel DRAC card opening, aligning the card with the back standoff.
Figure 3-16. Installing and Removing a DRAC Card
6
Align the front edge of the DRAC card with the two front plastic retention
standoffs adjacent to the DRAC system board connector, and press down
the side of the card until it is fully seated. See Figure 3-16.
When the front of the card is fully seated, the front plastic standoffs snap
over the front edge of the card.
1 DRAC-card connectors (2) 2 DRAC-card cables (2)
3 retention standoff hole 4 DRAC card
5 filler plug 6 support standoffs holes(2)
4
6
5
3
1
2
Book.book Page 94 Monday, September 14, 2009 12:57 PM