Filter
Top Products
Installing System Components 97
4
Disconnect the optical drive cable from the back of the drive.
5
To remove the optical drive, press down and forward on the blue tray
release tab and slide the drive tray out of the system. See Figure 3-17.
Figure 3-17. Removing and Installing the Optical Drive Tray
Installing the Optical Drive
1
Insert the optical drive tray into the system until it is fully inserted and
locked into position.
2
Connect the SATA cable (the end with the branching power cable) to the
back of the optical drive.
3
Connect the branching power cable to the power supply connector.
4
Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 80.
1 optical-drive cable 2 optical-drive release tab
3 optical -drive tray 4 optical drive
2
4
3
1
Book.book Page 97 Monday, September 14, 2009 12:57 PM