Filter
Top Products
140 Installing System Components
Installing the Control Panel Display Module
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1
Insert the display module into the chassis cutout and secure the module
with the two Torx screws. See Figure 3-29.
2
Attach the replacement panel to the front of the display module.
3
Connect the display module cable to the control panel board.
See Figure 3-29.
NOTE: Ensure that you release the cable clamp before connecting the cable
and then latch the clamp after connecting the cable.
4
Close the system. See "Closing the System" on page 77.
5
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
6
If applicable, replace the front bezel. See "Installing the Front Bezel" on
page 75.
book.book Page 140 Wednesday, February 17, 2010 6:17 PM