Filter
Top Products
48 About Your System
Unsupported CPU
combination
Unsupported CPU
stepping
detected.
Processor(s) is not supported
by the system.
Install a supported processor
or processor combination.
See "Processors" on page 125.
Unsupported DIMM
detected. The
following DIMM
has been
disabled: x
Invalid memory
configuration. The system
will run but with the
specified memory module
disabled.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 93.
Unsupported
memory
configuration.
DIMM mismatch
across slots
detected:
x,x,...
Invalid memory
configuration. Memory
modules are mismatched in
the specified slots.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 93.
Warning: A fatal
error has caused
system reset!
Please check the
system event log!
A fatal system error occurred
and caused the system to
reboot.
Check the SEL for
information that was logged
during the error. See the
applicable troubleshooting
section in "Troubleshooting
Your System" on page 151 for
any faulty components
specified in the SEL.
Warning: Front
Control Panel is
not installed.
The control panel is not
installed or has a faulty cable
connection.
Install the control panel, or
check the cable connections
between the control panel
board and the system board.
See "Control Panel
Assembly" on page 139.
Warning! No micro
code update
loaded for
processor n.
Micro code update failed. Update the BIOS. See
"Getting Help" on page 185.
Message Causes Corrective Actions
book.book Page 48 Wednesday, February 17, 2010 6:17 PM