Filter
Top Products
To remove the eject, power, and reset buttons, perform the following steps:
1. Lay the front bezel on a flat work surface, with the back of the bezel facing up.
2. To remove the 3.5-inch diskette eject button, pull gently on the plastic part of the button until it comes free.
3. To remove the power button or the reset button, use a small screwdriver and push in the two or three plastic clips that hold the button to the
bezel.
When these clips are released, the buttons come free from the bezel.
Front-Panel Inserts
Figure7.5.25-Inch Front-Panel Insert Removal
To remove a 5.25-inch front-panel insert, perform the following steps:
1. Hold the bezel with the front facing you.
2. From the front of the bezel, use your thumbs to press inward on the insert until it snaps free of the bezel.
To replace a 5.25-inch front-panel insert, position the two ring-tabs over the posts on the inside of the bay opening, and then press the ring-tabs
over the posts.
Control Panel
Figure 8. Control Panel Removal
1
Diskette eject button
2
Power button
3
Reset button
1
Front panel insert
2
Bezel
3
Ring-tab (2)