Filter
Top Products
NOTICE: You must match the blue connector on the interface cable to the IDE1 connector on the system board to avoid possible
damage to your system.
9. If it is not already connected, connect the blue connector of the EIDE cable to the IDE1 connector on the system board.
To locate the IDE1 connector, see "System Board Components."
10. Replace the computer cover. Then reconnect your computer and peripherals to their electrical outlets, and turn them on.
11. If the drive you just installed is the primary drive, insert a bootable diskette into the diskette drive (usually drive A).
12. Reset the chassis intrusion detector. While in System Setup, update the appropriate Primary Drive option, 0 or 1.
13. Partition and logically format your drive before you proceed to the next step.
See the documentation for your operating system for instructions.
14. If the drive you just installed is the primary drive, install your operating system on the hard-disk drive.
For instructions, refer to the documentation that came with your operating system.
System Power Supply
Figure 20. Power Supply Removal
To remove the system power supply, perform the following steps:
1. Disconnect the AC power cable from the back of the power supply.
2. Free the system power supply from the securing tab labeled "RELEASE —>" androtateitupwarduntilitlocks.
3. DisconnecttheDCpowercablesfromthesystemboardandthedrives.
Note the routing of the DC power cables underneath the tabs in the chassis as you remove them from the system board and drives. It is
important to route these cables properly when you replace them to prevent them from being pinched or crimped.
4. RemovethescrewabovetheACpowerreceptacle.
5. Lift up on the power supply cradle tab to release the power supply from the cradle and slide the power supply toward the front of the computer
approximately 1 inch.
1
Blue interface connector (on EIDE1)
2
Interface cable
3
Power cable
4
Power input connector on drive
5
Interface connector on drive
1
AC power cable
2
AC power receptacle
3
Power supply cradle
4
DC power cables
5
Securing tab